The Professional's choice.

The LevelAll is a single component, hands-free levelling and fixing device designed for Carpenters and Joiners to speed up the installation of door linings, kitchen units, wardrobes and all other items of fitted joinery.

Buy now Learn how it works
25 LevelAlls

The Starter Kit

25 + Drill bit

Everything you need to dip your toes into the water. 25 LevelAlls, the installation drill bit and a driver bit.

£27 inc. VAT

Buy now
50 LevelAll fixings

The Van Pack

50 + Drill bit

Fill up the toolbox and tackle your next large installation with ease. 50 LevelAlls, an installation drill and driver bit.

£47 inc. VAT

Buy now
100 LevelAll fixings

The Workshop Pack

100 + Free drill bit

Tackle your large joinery installation with ease. Fill your toolbox and your workshop drawer.

£67 inc. VAT

Buy now

How it works

For door liners.

LevelAll replaces sliding wedges or fumbling with plastic packers.

View this post on Instagram

A post shared by Baobab Carpentry LTD (@baobab_carpentry_ltd)

  • 1
    Drill. Using the supplied LevelAll drill and tap, cutting a thread directly into the door liner
  • 2
    Adjust Using the 6mm hex supplied, screw the LevelAll until the unit is level and fully supported against the wall
  • 3
    Snap and Fix Remove the excess shaft with a quick strike of your hammer, chisel, or cut off with a multi-tool. Cinch tight with a No.5 or greater screw - and you're done.
  • A quicker, more accurate fit for just £5.50 per door lining

Unlike sliding wedges or packers, the LevelAll won't be compressed by the screw being driven home, so the liner will stay exactly where you set it. No more backing out screws to fit "just one more" green packer. A better process, saving you time and making you more money.

Buy now

How it works

For cabinetry.

LevelAll will bridge any gap between 2mm and 40mm

View this post on Instagram

A post shared by Levelall Ltd (@levelall_ltd)

  • 1
    Drill. Using the supplied LevelAll drill and tap, cutting a thread directly into the cabinet back
  • 2
    Adjust Using the 6mm hex supplied, screw the LevelAll until you reach level and/or plumb
  • 3
    Snap and Fix Remove the excess shaft with a quick strike of your hammer, chisel, or cut off with a multi-tool. Cinch tight with a No.5 or greater screw - and you're done.
  • 4
    Cover up The LevelAll hole is just 10mm in diameter, so it can be covered by a KwikCap, or hidden behind a hinge plate.
  • A quicker, more accurate fit for just £1.36 a cabinet
Buy now